Watch an engineer debunk a myth you’ve heard your whole life

Watch an engineer debunk a myth you’ve heard your whole life
Dan Kitwood/Getty Images

So…have you ever heard the logic that a car needs back pressure in the exhaust to run properly? The good folks at Engineering Explained posted a new video on YouTube that basically says that’s all crap.

Mechanical engineer Jason Fenske lays it all out this way: too many people who think they know what they’re talking about are confusing exhaust back pressure with exhaust scavenging. Back pressure will prevent the gasses of combustion from escaping the cylinder when the valve opens. It impedes the exhaust flow is what Fenske says.

What is beneficial is to allow proper exhaust velocity which in turn will create the exhaust scavenging. As the gasses escape the cylinder as a pressure wave and hits a cross-sectional change in the pipe, it sends back a pressure wave. When a section of the pipe increases in diameter, the pressure wave that is sent back is a negative wave. That’s what you want, a negative pressure wave to arrive at the cylinder head before the outtake valve closes. He describes it this way.

“You want to time it so that just before that exhaust valve closes and your intake valve opens, that negative pressure wave arrives and helps lower the pressure in there, pulling out the remaining exhaust gasses so you have basically an entire empty chamber.”

Fenske goes on to say that the negative or low pressure created also helps bring in new air when the intake valve opens. This, he says, is wholly dependent on the length of pipe used for the exhaust. So now you know.

Read also:
The RCCI engine uses both gasoline and diesel fuel

Check Also

What is an octane rating and what does it mean?

You pull up to the pump and you are presented with a few choices, and we're not talking about different fuel types here. We're talking, of course, about octane ratings. Those are large figures at the fueling station, and you know if you press the higher one you're going to spend more money. Why is that and what does is all mean? Jason Fenske from...

Why Ford’s flathead V-8 engine died

Ford's famed flathead V-8 was revolutionary when the automaker put the engine into production in 1932. After over two decades of service, the flathead V-8 engine was finally laid to rest in favor of an overhead valve design. Why did Ford kill the innovative V-8 engine? That's a job for Jason Fenske of Engineering Explained to tell us about. Jason takes the...